Back Home
  Search


 

Receiver > RW-2040-150-P

 

Specifications of RW-2040-150-P


1.TYPE

Dynamic receiver for telephone handset.

2.ELECTRICAL CHARACTERISTICS

2.1 TEST SET UP

Shown in Fig.2

2.2 IMPEDANCE

150 ohm±20%(at 1KHz 60mV sine wave)

2.3 SENSITIVITY

    89±2dB S.P.L. (at 1KHz 60mV sine wave)

2.4 DISTORTION

    <5% (300…3400Hz)

2.5 FREQUENCY RESPONSE

    The frequency response relative to the 1KHz response shall Lie between the upper and lower limits show in Fig.1

3.MECHANICAL DATA

3.1 DIMENSIONS

ф20mm X 4.0mm
shown in Fig.3

3.2 WEIGHT

2.5±0.2g

Fig.1

A. SENSITIBITY

    • Set decade resistor R to 150 ohm
    • Ser switch S1 to position 1
    • Set osc. frequency to 1000Hz
    • Set Eg to 0.120 VRMS
    • Read the S.P.L. indicator

    B. FREQUENCY RESPONSE
    • Set decade resistor R to 150 ohm
    • Ser switch S1 to position 1
    • Set osc. frequency to 1000Hz
    • Set Eg to 0.120 VRMS
    • Vary frequency from 100 to 5000Hz. The frequency response shall fall within the limits of Fig.1

    C. AUDIBLE NOISE
    • Set decade resistor R to 0 ohm
    • Ser switch S1 to position 2
    • Set VISUAL voltage to 0.86VRMS
    • Listen to speaker output: It must be free of audible noise (buzzes and rattles)through the 300 to 3000Hz frequency range.
    • Fig.2

4.ENVIROMENTAL TESTS

4.1 GENERAL

After any following test, the response at 1KHz shall not deviate more than 3dB from the initial value.

4.2 HIGH TEMPERATURE TEST

a. Temperature: +65℃±3℃
b. Duration: 96 hours
c. Duration of recovery: 2 hours

4.3 LOW TEMPERATURE TEST

a. Temperature: -25℃±3℃
b. Duration: 96 hours
c. Duration of recovery: 2 hours

4.4 HUMIDITY TEST

a. Relative humidity: 90-95% at +40℃
b. Duration: 96 hours
c. Duration of recovery: 2 hours

4.5 TEMPERATURE CYCLING TEST

a. Temperature cycling diagram
b. Number of cycles: 4 cycles
c. Duration of recovery

4.6 VIBRATION TEST

a. Vibration direction: 3 axes
b. Frequency: 55 Hz
c. Vibration amplitude: 1.5 mm
d. Duration: 30 minute in each plane

4.7 DROP TEST

a. Unit only: The receiver shall withstand 10 random drops from a height 75cm to a concrete floor, and no mechanical damage.

b. Fixed in handset: The receiver when properly mounted in a handset, shall withstand 6 random drops from a height of 1.5 meters to a concrete floor, and no mechanical damage, and no change the 1KHz response level.

 
 
MynTahl Copyrights @ 2003, all rights reserved.